Service Tel:
中文PRODUCTS
- Mechanical seal of boiler feed pump
- Mechanical seal of circulating pump
- Slurry pump mechanical seal
- Mechanical seal of desulfurization
- Mechanical seal of agitator
- Compressor mechanical seal
- Sewage pump mechanical seal
- Chemical pump mechanical seal
- Metal bellows mechanical seal
- Heat conduction oil pump mechanical
- Mechanical seal of sanitary pump
- Clean water pump mechanical seal
- Mechanical seal of booster pump
- Air-conditioning pump mechanical se
- Mechanical seal of reaction kettle
- Mechanical seal of Chinese standard
- Mechanical seal of paper pulp pump
- Mechanical seal of pressure screen
- Water pump accessories
Mechanical seal, typical flow pump with a multi-spring typical mechanical seal, is widely used standard non-balanced mechanical seal, allow the use of various materials and end face combination, mainly used in chemical pumps, sewage pumps, pipeline booster pumps and submersible pumps, etc.
Working parameters
Rules: age from 25 to 85 mm
Pressure: 1.2 Mpa or less
The temperature: - 80-250 ℃
Line speed: ≤30m/s
Axial channeling momentum: ±0.5mm
Material combination
Sealing end face: graphite, silicon carbide, tungsten carbide, alumina ceramics
Auxiliary sealing: nitrile rubber, fluorine rubber, ethylene rubber, silicone rubber
Metal component: SUS304, SUS316L
The product description
Single face built in type
The balanced
Drive sleeve drive
Comply with EN12756(DIN24960) standards
In the development and design of any product, we follow the principle of installation size standardization. That is, the installation ruler of this type of mechanical seal is in accordance with international and domestic (API610, API682, DIN24960, ISO3069, GB6556).
